American DJ Mega Bar LED RC 1 Meter LED Bar
American DJ Mega Bar LED RC 1 Meter LED Bar
American DJ introduces the Mega Bar LED RC, a 40-inch (1-meter) LED lighting Bar. With the power of RGB color mixing for stage or wall washing featuring an Infrared wireless remote. Control what would normally require a DMX controller or adjustments made by hand on the rear panel. Control features such as: Black Out, built-in programs, flash, DMX addressing and RGB color change with the touch of a button on the remote control.
This fixture uses LEDs rated at 100,00 hours with a maximum power draw of 30W. DMX addressing may also be changed by the unit’s 4-button LED display. There is no duty cycle on the Mega Bar LED RC, plus users can “daisy-chain” the power from one unit to the next with the built-in IEC power Ins/Outs.
Features / Specifications:
- Ultra bright, indoor LED Color Bar with 251 10mm LEDs (48 Red, 108 Green, & 95 Blue LEDs
- Includes wireless infrared remote control up to 30 ft./10M (Model: ADJ LED RC)
- 6 DMX Channel modes: 2, 3, 4, 6, 7 or 11 channel modes
- 5 operational modes, Program mode, Auto mode, Sound mode, Master/Slave mode & DMX mode
- Great as an architectural wall wash or for performance stages where traditional stage lighting emit a lot of heat onto performers
- Smooth RGB color mixing (fast or slow color change operation)
- Built-in Color Macros
- Color strobe effect
- DMX-512 Protocol
- Electronic Dimming: 0 – 100%
- Beam angle: 40-degree
- Linkable via 3-pin XLR cable
- 4-button LED display on rear panel
- IEC AC outlet on rear to daisy chain power
- Includes mounting brackets
- Long life LED (Rated at 100,000 hrs.)
- Low power consumption
- Very low heat output
- Run all night – No duty cycle
- Power Draw: 30W max
- Multi-voltage: 90-240V, 50/60Hz
- Dimensions (LxWxH): 40.5″ x 2.75″ x 3.5″ / 1025x65x88 mm
- Weight: 8 lbs. / 2.8 kgs.
ADJ LED RC Infrared Remote Control Features:
- Black Out: Turns fixture On/Off
- Auto Run: Automatically run through built-in programs
- Program Selection: Access units built-in programs
- Flash: Strobe effect
- Speed: Control speed of Auto Run
- DMX Mode Select
- Sound Active: Activates sound active mode
- Slave: Designates the fixture as a “slave” fixture in the Master/Slave configuration
- Set Address: Set DMX Address on a fixture
- RGB Buttons: Adjust RGB colors with the “+” and “-” buttons
- + and – Buttons: Adjust flash rate, speed of the Auto Run and Program Selection
