Carver PT-1800 2-Channel Audio Amplifier
Carver PT-1800 2-Channel Audio Amplifier
The power amplifier being of two channels, shall deliver 600W into 8 ohms per channel, 900W into 4 ohms per channel. The amplifier shall be capable of providing 650W per channel into a 70 volt distribution system without the need for step-up transformers. The amplifier being of two completely independent power supplies per channel shall be capable of operating from separate AC branch circuits and to provide independent operation with the exception of the series (bridge-mono) mono and the parallel mono operation. The amplifier shall be capable of series bridge-mono operation thereby providing 1800W RMS output into 8 ohms. The amplifier shall have a thermal shutdown system to protect the power devices from over-temperature operation. This thermal protection system shall be self-resetting. The amplifier shall provide input limiting to protect the output devices against short circuits or against non-musical excessive high frequency signals. Each amplifier shall independently shut down to protect against DC offset present at the outputs, or an internal power supply fault. The amplifier shall have slow start up and muted inputs on turn-on. The amplifier shall have a voltage gain of 32dB. Noise shall be at least -100dB below 600 W/8ohm, A-Weighted, from 20Hz-20kHz. Total harmonic distortion shall be less that 0.5% and inter modulation distortion shall be less that 0.1%. The frequency response shall be less than ±0.5dB, 20Hz-20kHz. The front panel controls shall consist of per channel; one level control, one master power switch and one sequence switch. The rear panel connectors shall consist of per channel; 3 input barrier terminals, one 3-pin locking input connector, two sets of dual bind post output connectors, two barrier sequence terminals and one positive locking AC power cord. The amplifier shall provide input configuration switches to allow in rack selection of dual mono, series mono, clip eliminator and 3-pin polarity configuration. A cooling fan with removable filter shall operate on two speeds that is determined by the heat sink temperature. The dimensions shall allow for standard 19* EIA rack mounting. It shall be 5.25″ high and 12.75″ deep. The amplifier shall weigh 46 pounds. The maximum input current requirements per channel for a 900W output in to 4 ohms shall be 17 amps at 120V, 60Hz.
Specifications:
- 8-ohm FTC rated power/ch – 600W
- 4-ohm FTC rated power/ch – 900W
- 2-ohm dynamic power/ch – 1100W
- Center Channel Power
- Rear Channel Power
- Bridged mono power
- Parallel mono power
- 4/8-ohm FTC rated THD – < 0.5% THD
- IM Distortion
- CMRR
- Input Impedance (Line) – 5K ohms each leg
- Input Sensitivity
- Gain 32 dB
- Rated full power bandwidth
- S/N-IHF A-Weighted,dB
- Slew Rate 25V/us
- Power Consumption
- Fusing
- Dynamic Headroom
- Damping 200 @ 1kHz
- Dimensions (HxWxD inches) – 5.25″ x 19″ x 12.75″
- Connections – Input: XLR, barrier strip Output: 5-way binding posts, 2 sets/channel
